產品分類

Cassification

技術文章/ Technical Articles

您的位置：首頁 / 技術文章 / 安科瑞無線測溫產品在南京祿口國際機場項目的應用

安科瑞無線測溫產品在南京祿口國際機場項目的應用

更新時間：2022-01-22

瀏覽次數：549

摘要：高壓開關柜在運行過程中，柜內觸點與母線連接處、動靜觸頭電路發熱過大，易引發停電和火災事故。因此，高壓開關柜內溫度監測尤其是三相觸點溫度監測非常重要。高壓設備存在裸露電壓，傳統的有線溫度檢測方法因無法解決高壓絕緣問題而不能應用。無線測溫系統采用無線電波進行信息傳輸，不需要布線，與高壓設備等電勢，不需要采取絕緣措施。因而無線測溫系統可解決高壓設備測溫難題。

Abstract: During the operation of the high-voltage switchgears, The contact in the cabinet and the bus connection, the dynamic and static contact circuit generates too heat, which is easy to cause power failure and fire accident. Therefore, the temperature monitoring is very important in the high-voltage switch cabinet, especially the three-phase contact temperature monitoring. The traditional wired temperature measurement method can not be used because of the exposed voltage of high voltage equipment. The wireless temperature measurement system uses radio waves, no wiring, equal potential with high-voltage equipment, and no insulation measures. Therefore, the wireless temperature measurement system can solve the temperature measurement problem of high-voltage equipment.

關鍵詞：高壓開關柜，無線測溫系統

Keywords: high-voltage switchgears，Wireless Temperature Monitoring System

0.項目概述：Project Overview

本項目為南京祿口國際機場T1航站樓改擴建場外供配電工程，需要配置無線測溫產品，實現對柜內斷路器的溫升監測。傳感器工作環境溫度滿足-40℃到+120℃需求。選擇我司ATE300型CT感應取電式傳感器。并且采用ATC400收發器連接后臺系統。

This project is the expansion project of the T1 terminal of Nanjing Lukou International Airport. It needs to be equipped with wireless temperature measurement products to realize the temperature rise monitoring of the circuit breakers in the cabinet.The working environment temperature of the sensor meets the requirement of -40℃ to +120℃. Choose ATE300 type CT inductive powered temperature sensor. And choose the ATC400 transceiver to connect to the background system.

1.無線測溫系統介紹

　Wireless Temperature Monitoring System Introduction

無線測溫系統適用于3-35kV室內開關柜，包括內置開關柜，手推車開關柜，固定開關柜和環網開關柜。它也適用于0.4kV低壓開關設備，例如固定開關設備和抽屜式開關設備。

　Wireless Temperature Monitoring System is suitable for 3-35kV indoor switchgears, including built-in switchgears, handcart switchgears, fixed switchgears and loop-net switchgears. It is also suitable for 0.4kV low-voltage switchgears such as fixed switchgears and drawer switchgears.

2.無線測溫配置方案

　Wireless Temperature Monitoring Configuration Scheme

1）高低壓柜內電氣接點無線測溫

　Wireless temperature monitoring of contacts in high and low voltage cabinets